American Dryer Corp. AD-385 - Manual (Page 24)

Providing local codes permit, power to the dryer can be made by the use of a flexible U.L.
listed cord/pigtail (wire size must conform to the rating of the dryer), or the dryer can be hard
wired directly to the service breaker. In ALL cases, a strain relief must be used where the wiring
enters the dryer and the service box.
A wire diagram is located inside the control box area for connections data.
1.) Single Phase (1 0) Model (Hookup) Connections
The electrical input connections to the dryer the two (2) power lead connections (LI and N
or L2) and the ground.
S/NGLE PHASE 110) ELECTRICAL CONNECTIONS
60 HZ 50 Hz
ELECTRIC POWER COWCCriCWS ELECTRIC POWER CONNECTIONS
BLACK WHITE GREEN BLACK RED GREEN
* -
Olr
* -
0^
POSITIVE HEUTRAL GROUND POSITIVE neutral ground
STUD STUD
The two (2) power connections are made at the motor contactor (LI and L2 termination
points) located inside the electrical service box. The ground connection is made at the
ground lug also provided in this service box.
Providing local codes permit, power to the dryer can be made by the use of a flexible U.L.
listed cord/pigtail, or the dryer can be hard wired directly to the service breaker. In ALL
cases, a strain relief must be used where the wiring enters the dryer and service box.
20