B. adtustments, C. lubrication, B. adjustments – American Dryer Corp. AD-385 User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BODAYS
Inspect and remove lint accumulation in customer furnished exhaust duct work system and
from dryers internal exhaust ducting.
NOTE: THE ACCUMULATION OF LINT IN THE EXHAUST DUCT
WORK CAN CREATE A POTENTIAL FIRE HAZARD.
NOTE: DO NOT OBSTRUCT THE FLOW OF COMBUSTION and VENTI
LATION AIR. CHECK CUSTOMER FURNISHED BACK DRAFT
DAMPERS IN THE EXHAUST DUCT WORK. INSPECT and RE
MOVE ANY LINT ACCUMULATION WHICH CAN CAUSE THE
DAMPER TO BIND or STICK.
NOTE: A back draft damper that is sticking partially closed can result in
slow drying and shutdown of heat circuit safety switches or ther
mostats
NOTE: When cleaning the dryer cabinet(s), avoid using harsh abrasives.
A product intended for the cleaning of appliances is recommended.
B. ADTUSTMENTS
7
DAYS AFTER INSTALLATION and EVERY 6 MONTHS THEREAFTER
Inspect bolts, nuts, screws, (bearing set screws), non-permanent gas connections (unions,
shut-off valves, orifices, and grounding connections). Motor and drive belts
should be
examined. Cracked or seriously frayed belts
should be
replaced. Tighten loose V-belts when
necessary. Complete operational check of controls and valves. Complete operational check of
ALL safety devices (door switches, lint drawer switch, sail switch, burner and hi-limit
thermostats).
C. LUBRICATION
The motor bearings, idler bearings, and tumbler bearings are permanently lubricated.
NO
LUBRICATION IS NECESSARY.
36