Aiwa XR-M88 - Manual (Page 16)

Al EDIT RECORDING
0-9,+10
CD EDIT CD
C 5CDCD!
0(DC3CDa r-aalool
C 3 CD
CÉIO
0 0 0
SHIFT •REC/
REC MUTE
The Al edit function enables CD recording without worrying about
tape length and track length. When a CD is inserted, the unit
automatically calculates track lengths. If necessary, the order of
tracks is rearranged so that no track is cut short.
(Al: Artificial Intelligence)
NOTE
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.
1 Load the tape into the cassette deck.
Load the tape with the side to be recorded on first facing
upward.
2 Press the CD button on the remote control, or
press repeatedly the FUNCTION button on the CD/
tape unit so that “CD” is dispiayed, and ioad the
disc.
3 Press the CD EDIT button repeatedly while
pressing the SHiFT button on the remote controi
until “EDIT” lights up and “Ai” flashes on the
display.
cz:>
H I
. м :: м i"ì
Press the numbered buttons to designate the tape
length.
10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press the 6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
• The ◄◄ and ►► buttons are also available to designate
the tape length.
i"i i:
! !...!■": !■■■;
Tape side A o Tape length
... i:;j !! I;;;:
Number of programmed
tracks
Remaining time of side A
5 Press the # REC button on the CD/tape unit to
start recording.
To start recording with the remote control, press the # REC/
REC MUTE button and within 2 seconds, press the ► button.
The tape is rewound to the beginning of the side facing upward,
the lead segment is played through for 10 seconds, and
recording starts. When recording on the side facing upward
(side A) ends, recording on the opposite side (side B) starts.
To stop recording
Press the ■ button. Recording and CD play stop simultaneously.
To clear the edit program
Press the ■ button twice so that “EDIT” disappears on the display.
To check the order of the programmed track numbers
Before recording, press the CD EDIT button while pressing the
SHIFT button on the remote control to select side A or B, and
press the ►► button repeatedly.
Tape side Program number
I i
hi > T 1.
Track number Programmed track
numbers
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This system
can program tracks to use the extra time.
> Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
• The Al edit function cannot be used with discs containing 31
tracks or more.
1 6
ENGLISH