Before operation, To turn the system on, To turn the system off – Aiwa XR-M88 User Manual
Page 6: Using the headphones, To use the function button on the cd/tape unit, Using the remote control, When to replace the batteries, Opening and closing the top cover, When to use the remote control
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE OPERATION
FUNCTION
POWER
Remote
sensor
PHONES
To turn the system on
Press one of the function buttons (TUNER/BAND, AUX/MD, CD,
TAPE) on the remote control.
Playback of the corresponding source starts (Direct Play
Function).
The POWER button is also available.
To turn the system off
Press the POWER button again.
Using the headphones
Connect headphones with a stereo mini plug (03.5 mm, Va inch)
to the PHONES jack.
No sound is output from the speakers while the headphones are
plugged in.
To use the FUNCTION button on the CD/tape unit
The FUNCTION button on the CD/tape unit substitutes for the
function buttons (TUNER/BAND, AUX/MD, CD, TAPE) on the
remote control. Each time the FUNCTION button is pressed while
power is on, the next function is selected cyclically.
USING THE REMOTE CONTROL
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R03 (size AAA) batteries.
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the CD/tape unit should be approximately 5
meters (16 feet). When this distance decreases, replace the
batteries with new ones.
Opening and closing the top cover
When to use the remote control
Some operations can be performed using the buttons on the
remote control only, while others can be performed using the
buttons on the CD/tape unit as well as on the remote control.
This instructions manual clearly describes the buttons available
for each operation.
• The ► button on the remote control has the same function as
that of the button on the CD/tape unit.
• If the system is not going to be used for an extended period of
time, remove the batteries to prevent possible electrolyte
leakage.
• The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor is exposed to intense light, such as direct sunlight.
- Other remote controls are used nearby (television, etc.)
The number buttons from 1 to 9 also have the functions indicated
on the plate above them. To use these functions, press the
buttons while pressing the SHIFT button on the remote control.
ENGLISH