Aiwa XR-M88 - Manual (Page 18)

TIMER PLAY AND TIMER
RECORDING___________
-TIMER
c:>ooo
dbocDO
C3000 _____ _
|apoc3C3 QIQQH —
QO
®-i o o o ® 0 0
POWER
SHIFT
-II
The system can be turned on at a specified time every day with
the buiit-in timer.
Make sure the clock is set correctiy. (See page 7.)
Use the remote controi.
1 Prepare the source and recording destination.
To listen to a CD, press the CD button on the remote control
and load a CD.
To listen to or record from a radio broadcast, press the
TUNER/BAND button on the remote control and tune in to a
station.
To listen to or record from the connected equipment, press
the AUX/MD button on the remote controi repeatedly until the
corresponding source appears on the display, and set the timer
of the equipment to start playing at the required timer-on time.
2 Press theTIMER button repeatedly while pressing
the SHIFT button on the remote control to display
“TIMER ©PLAY” (for timer play) or “TIMER
0REC” (for timer recording).
TIMER 0REC
TIMER ©PLAY : for timer play
TIMER ©REC ; for timer recording
3 Within 4 seconds, designate the timer-on time by
pressing the ◄◄ or ►► button.
Pressing the ◄◄ button once will move the time back by 1
minute, and pressing the ►► button once will advance the
time by 1 minute.
Holding these buttons down will vary the time in 10-minute
units.
4 Press the II button.
When timer play is selected;
EM 1 20:-
When timer recording is selected:
EM R120..
5 Select the duration for the timer-activated period
with the ◄◄ or ►► button.
C;:D
/ ii ^
Timer-activated period
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
6 Press the II button.
If 4 seconds elapse without the II button pressed, the timer
set in steps 1 through 5 becomes effective.
7 For timer recording, load the tape to record on.
8 Press the POWER button to turn the system off
after adjusting the volume and tone.
© or ©ES remains on the display after the power is turned
off (timer standby mode).
Note, however, that everything on the display will clear if the
power economizing mode (see page 7) is activated. To confirm
the timer standby mode, press the MODE button while
pressing the SHIFT button on the remote control to turn off
the power economizing mode.
When the timer-on time is reached, the system turns on and
begins play (or recording) with the selected source.
If the volume level was set to higher than 21 when the power
was turned off, it is automatically set to 21 when the system
turns on by the timer.
1 8
ENGLISH