Manual tuning, Press the ◄◄ or ►► button to select a station, When an fm stereo broadcast contains noise – Aiwa XR-M88 User Manual
Page 9: To change the am tuning interval, To change the display, About the level indicator, To search for a station quickly (auto search), F m 9 8 . 0 0 m h z, F m 9 8 : : 0 0 m h z
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
RADIO RECEPTION
MANUAL TUNING
DISPLAY
TUNER/BAND
'.1 b'./'.. .)
—
Q
o c o O O
O
SHIFT MONO
1 Press the TUNER/BAND button on the remote
control (or the FUNCTION button on the CD/tape
unit) repeatedly to select the desired band.
FM
AM^
If the power is turned off, the previously tuned station will be
played (Direct Play Function).
Press the ◄◄ or ►► button to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for 2 seconds.
During FM stereo reception, (Ucn)i)) is displayed.
{II0III
F M 9 8 . 0 0 M H z
When an FM stereo broadcast contains noise
Press the MONO button on the remote control.
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
MONO
F M 9 8 : : 0 0 M H z
To restore stereo reception, repeat the above again
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this system in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the
II
button on the
CD/tape unit.
To reset the interval, repeat this procedure.
3
o
(0
o
lU
u
UJ
tc
o
Q
<
cr
When the AM tuning interval is changed, all preset stations (see
“PRESETTING STATIONS”) are cleared.The preset stations have
to be set again.
To change the display
Press the DISPLAY button while pressing the SHIFT button on
the remote control. With each press of the button, the display
changes in the following order,
r»® Level indicator
'—@ Frequency of the tuned station
(Example: FM 98.00MHz)
About the level indicator
The above display automatically changes to the level indicator
after 4 seconds.
The level indicator shows an approximate playback sound level.
To search for a station quickly (Auto Search)
Keep the ◄◄ or ►► button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
.
To stop the Auto Search manually, press the ◄◄ or ►► button.
• The Auto Search may not stop at stations with very weak signals.
ENGLISH
9