Dolby Laboratories DP503 - Manual (Page 19)

2A-3
Installation involves:
N Equipment mounting
N Audio connections
N Data / Status / Control connections
Using the “Y” cable to interconnect the DP503, DP524 and ISDN unit
N Applying power
N Analog audio calibration
N ISDN connections
2A.4 Quick Start for ISDN Setup
Note: Refer to Section 5 for a comprehensive procedure and details on user interface. Section 6.3 is
devoted to ISDN Setup. Refer also to Appendices D & E for ISDN background information.
1. Select ISDN Setup by pressing SHIFT + DIR
2. Pick the appropriate switch type under the menu heading SW.
3. Enter your phone numbers (and SPIDs, if needed) under the menu headings
L1, L2, L3, L4 as needed (typical Dolby Fax installations use only 2 lines,
so only L1 and L2 will be used.). Leave unused lines disabled.
4. Store ISDN settings by pressing the ESC key and answering Y to the
UPDATE TA? inquiry.
5. Reset the ISDN unit by cycling mains power.
2A.5 Quick Start for Developing a Phone Directory
Notes: Refer to Section 5.4 for a comprehensive procedure on entering directory items.
Do not begin a Dolby Fax directory entry with an asterisk, as that signifies an encoder-only entry (See Section
6.4.2)
1. Press DIR.
2. Select NEW. Use COPY ENTRY if modeling a new entry from an
existing one.
3. Enter required information. Be sure that encoder and ISDN unit parameters
match the capabilities of the site you will be calling. Default Dolby Fax
entries are:
MAIN