ADLINK aTCA-N700 - Manual (Page 26)

aTCA-N700 SW Users Guide
２０
CPU0:1200 MHz, CPU1:1200 MHz, CPU2:1200 MHz, CPU3:1200 MHz,
CCB:600 MHz,
DDR:600 MHz (1200 MT/s data rate) (Asynchronous), LBC:37.500 MHz
FMAN1: 500 MHz
PME: 300 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: aTCA-N700, 36-bit Addressing,
bank#1 -> this shows active flash
number
I2C: ready
SPI: ready
DRAM: Detected UDIMM i-DIMM
DDR: 2 GiB (DDR3, 64-bit, CL=8, ECC on)
Date: 2013-07-16 (Tuesday) Time: 20:33:54
IPMC: OK
Manuf.: ADLINK Technology
Name: aTCA-N700
Part#: aTCA-N700
Version: A2
Serial#:
Slot: 4
Reset: FRU control command(opt.: cold reset)
L2: 128 KB enabled
L3: 1024 KB enabled(Corenet Platform Cache)
MMC: FSL_ESDHC : Card is not detected
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
EEPROM:OK
PCIe1: Root Complex, x1, regs @ 0xfe200000
01:00.0 - 177d:0091 - Processor
PCIe1: Bus 00 - 01
PCIe2: Root Complex, x2, regs @ 0xfe201000
03:00.0 - 14e4:b842 - Network controller
PCIe2: Bus 02 - 03
PCIe3: Root Complex, x1, regs @ 0xfe202000
05:00.0 - 177d:0091 - Processor
PCIe3: Bus 04 - 05
In: serial
Out: serial
Err: serial
XGS: 0xa0000868 : 0xd13f0201
OK(0.9V)
ROBO: OK
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
Net: Initializing Fman
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
Fman1: Uploading microcode version 106.1.4
FM1@DTSEC4, FM1@DTSEC5
Hit any key to stop autoboot: 0
=>
ipmi active-flash -> shows current active flash (result = 0 or 1)
active-flash: 1 -> means active-flash is the second one.
=>
ipmi switch-active -> change active flash to the first one (toggle fashion).
-> A reset occurs automatically.
U-Boot 2011.09-svn118 (Jul 08 2013 - 19:25:54)
CPU0: P2041E, Version: 1.1, (0x82180111)
Core: E500MC, Version: 2.2, (0x80230022)
Clock Configuration:
CPU0:1200 MHz, CPU1:1200 MHz, CPU2:1200 MHz, CPU3:1200 MHz,
CCB:600 MHz,