ADLINK aTCA-N700 - Manual (Page 57)

aTCA-N700 SW Users Guide
５１
** Run rcload.
BCM.0> rcload /tmp/traffic_10G_NP_RTM1_FABRIC
8.3.10. Switch configuration
Switch initialization uses /usr/local/bcm/config.bcm.atca3700 file. Switch can be
restarted after this file is updated(/etc/init.d/bcm.sh restart). Also it can be updated in
BCM shell.
Usage (CONFig): Parameters: show | refresh | save | [add] [<var>=<value>] | delete
<var>
If no parameters are given, displays the current config vars.
show display current config vars
refresh reload config vars from non-volatile storage
save save config vars to non-volatile storage
<var>=<value> change the value of a config var
add <var>=<value> create a new config var
delete <var> deletes a config var
clear deletes all config vars
= prompt for new value for each config var
NOTE: changes are not retained permanently unless saved
Some configuration examples are described below.
** Display configuration values
BCM.0> config show
os=unix
bcm_num_cos=4
tdma_intr_enable=1
tslam_intr_enable=1
tslam_dma_enable=1
dport_map_enable=1
dport_map_indexed=1
dport_map_direct=1
bcm_xlate_api_port_enable=1
bcm_xlate_port_enable=1
xgxs_lcpll_xtal_refclk=1
load_firmware=1
pbmp_xport_xe.0=0x0000000000ffffffe
portmap_1.0=1:10
portmap_2.0=2:10
portmap_3.0=3:10
portmap_4.0=4:10
portmap_5.0=61:10
portmap_6.0=63:10
portmap_7.0=65:10
portmap_8.0=69:10
portmap_9.0=5:10
portmap_10.0=7:10
portmap_11.0=8:10
portmap_12.0=13:10
portmap_13.0=33:10
portmap_14.0=29:10
portmap_15.0=57:10
portmap_16.0=58:10
portmap_17.0=59:10
portmap_18.0=60:10
portmap_19.0=53:10
portmap_20.0=54:10
portmap_21.0=55:10