ADLINK aTCA-N700 - Manual (Page 27)

aTCA-N700 SW Users Guide
２１
DDR:600 MHz (1200 MT/s data rate) (Asynchronous), LBC:37.500 MHz
FMAN1: 500 MHz
PME: 300 MHz
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Board: aTCA-N700, 36-bit Addressing,
bank#0 -> this shows active flash
number
I2C: ready
SPI: ready
DRAM: Detected UDIMM i-DIMM
DDR: 2 GiB (DDR3, 64-bit, CL=8, ECC on)
Date: 2013-07-16 (Tuesday) Time: 20:39:20
IPMC: OK
Manuf.: ADLINK Technology
Name: aTCA-N700
Part#: aTCA-N700
Version: A2
Serial#:
Slot: 4
Reset: FRU control command(opt.: cold reset)
L2: 128 KB enabled
L3: 1024 KB enabled(Corenet Platform Cache)
MMC: FSL_ESDHC : Card is not detected
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
EEPROM:OK
PCIe1: Root Complex, x1, regs @ 0xfe200000
01:00.0 - 177d:0091 - Processor
PCIe1: Bus 00 - 01
PCIe2: Root Complex, x2, regs @ 0xfe201000
03:00.0 - 14e4:b842 - Network controller
PCIe2: Bus 02 - 03
PCIe3: Root Complex, x1, regs @ 0xfe202000
05:00.0 - 177d:0091 - Processor
PCIe3: Bus 04 - 05
In: serial
Out: serial
Err: serial
XGS: 0xa0000868 : 0xd13f0201
OK(0.9V)
ROBO: OK
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
Net: Initializing Fman
SF: Detected SST25VF080B with page size 4 KiB, total 1 MiB
Fman1: Uploading microcode version 106.1.4
FM1@DTSEC4, FM1@DTSEC5
Hit any key to stop autoboot: 0
=>
5.1.2. LMP OS Redundancy
The aTCA-N700 provides dual Chip SSD devices for a primary storage and a
redundant storage for the OS image.
To select one of the redundant images, use the following example.
=> run satabootA -> boot from the primary SSD storage.
SATA0 (1.5 Gbps)