ADLINK aTCA-N700 - Manual (Page 73)

aTCA-N700 SW Users Guide
６７
■ Obtain the SOL configuration parameters for a given channel.
ipmitool sol info <channel num>
Figure 11-11 Get SOL Configuration Parameters Command
■ Change one of the following SOL Configuration parameters.
Session privilege level (<param> = privilege-level)
Character accumulate interval (<param> = character-accumulate-level)
Character send threshold (<param> = character-send-threshold)
Retry count (<param> = retry-count)
SOL Enabled status (<param> = enabled)
Retry interval (<param> = retry-interval)
Non-volatile bit rate (<param> = non-volatile-bit-rate)
Volatile bit rate (<param> = volatile-bit-rate)
ipmitool sol set <param> <value>
■ Establish an SOL session with the payload and enter the terminal mode. The <IP
addr>, <user name> and <password> parameters are can be changed at run-time
using the commands described above.
Figure 11-12 Testing Serial-over-LAN
■ You can terminate a SOL session entering “~.” from the terminal.