AMT Datasouth 2012 M6 Plus - Manual (Page 35)

3.1.1-1.1 Speed:
29
Use this option to setup print speed. Each increment/decrement is 1 ips. Printer default density
is 5 ips (203 dpi) or 3 ips(300 dpi).
Press key to raise the print speed, and press key to decrease print speed.
Press key to set it into printer. Press key to cancel the setting and
return to the previous menu.
Note: If printing from enclosed software/driver, “Use current printer settings” option is
not selected, the software/driver will send out the SPEED command, which will
overwrite the setting set from the front panel.
3.1.1-1.2 Density:
Use this option to setup printing darkness. The available setting is from 0 to 15 levels, and the
increment is 1 level. Printer default density is 8.You may need to adjust your density based on
selected media/ribbon.
Press and to increase/decrease the printing darkness. Press
key to enable the setting. Press key to cancel the setting and return to the
previous menu.
Note: If printing from enclosed software/driver, the “Use current printer settings” option
is not been used, software/driver will send out the DENSITY command, which will
overwrite the setting set from the front panel.
3.1.1-1.3 Direction:
Print Setup 1/12
> Speed
Density
Direction
Speed
6
Print Setup 2/12
Speed
> Density
Direction
Density
8
Print Setup 3/12
Speed
Density
> Direction
Direction
0