AMT Datasouth 2012 M6 Plus - Manual (Page 47)

3.1.1-2.14 Head Close:
41
This option is used to set the action of the media when you close the printhead. Printer default
setting is No Motion. When enter this list, the print mode in the right side of “ >” icon is the
printer current setting. Press and to select the different print mode and
press button to enable the setting. Press key to cancel the setting and
return to the previous menu.
Selections Description
Feed Printer will advance one label
Calibration
Printer will calibration the sensor levels, determine length and
feed label
Length Printer determine length and feed label
No Motion Printer will not move media
3.1.1-2.15 Label Top:
Print Setup 14/17
Delimiter Char
Media Power Up
> Head Close
Head Close 4/5
Length
> No Motion
Exit
Print Setup 15/17
Media Power Up
Head Close
> Label Top
Label Top
+000
This option is used to adjust print position vertically on the label. Press the button to
move the cursor from left digit to right digit, and press the button to set the value from
“+” to “-” or “0” to “1/2”. Press the button to set the value into printer. Press
key to cancel the setting and return to the previous menu. The default value is
+000 and range is -120 to +120 dots.