AMT Datasouth 2012 M6 Plus - Manual (Page 43)

“0” to “9”. Press the button to set the value into printer. Press key to
cancel the setting and return to the previous menu. The default value is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.4 Print Mode: (Tear Off / Peel Off / Cutter)
37
This option is used to set the print mode. Printer default setting is Tear Off. When enter this list,
the print mode in the right side of “ >” icon is the printer current setting. Press and
to select the different print mode and press button to enable the setting.
Press key to cancel the setting and return to the previous menu.
Printer Mode Description
Tear Off
Next label top of form is aligned to the print head burn line
location.
Peel Off Enable the label peel off mode.
Cutter Enable the label cutter mode.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.5 Print Width:
Print Setup 4/17
Print Speed
Tear Off
> Print Mode
Print Mode 1/4
> Tear Off
Peel Off
Cutter
Print Setup 5/17
Tear Off
Print Mode
> Print Width
Print Width
812 dot
This option is used to set print width. Press the button to move the cursor from left
digit to right digit, and press the button to set the value from “0” to “9” or “dot” to “mm”.
Press the button to set the value into printer. Press key to cancel the
setting and return to the previous menu.