AMT Datasouth 2012 M6 Plus - Manual (Page 56)

B-3 Pre-Printed
This function will need to set the paper length and gap size before auto-calibrate the
sensor sensitivity. It can get the sensor sensitivity more accurately for pre-printed
media.
Bline Mode 3/4
Manual
> Pre-Printed
Exit
When enter [Pre-Printed] option, you will see following message. Please complete there
steps
：
Paper Len.
00812 dot
1. Press the button to move
the cursor from left digit to right digit,
and press the
button to set
the value from “0” to “9” and the “dot/
mm/ inch”. Press the
button to set the paper length into the
printer.
Bline Size
0024 dot
2. Press the button to move
the cursor from left digit to right digit,
and press the
button to set
the value from “0” to “9” and the “dot/
mm/ inch”. Press the
button to set the bline size into the
printer.
Bline Mode
Pre-Printed
3. Then, printer will feed labels to
calibrate the sensor sensitivity
automatically. When calibration is
completed, the LCD screen will return
to the previous menu.
50