AMT Datasouth 2012 M6 Plus - Manual (Page 37)

Batch Mode
Once image is printed completely, label gap/black mark will be
fed to the tear edge for tear away.
Peeler Mode Enable the label peel off mode.
Cutter Mode Enable the cutter mode.
Cutter Batch Cut the media once at the end of the printing job.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-1.5 Offset:
31
This option is used to fine tune media stop location for peeler and cutter mode. Press the
button to move the cursor from left digit to right digit, and press the button to
set the value from “+” to “-” or “0” to “9”. Press the button to set the value into printer.
Press key to cancel the setting and return to the previous menu. The default value
is +000.
Note: If printing from enclosed software/driver, the software/driver will send out the
OFFSET command, which will overwrite the setting set from the front panel.
3.1.1-1.6 Shift X & Shift Y:
Print Setup 5/12
Direction
Print Mode
> Offset
Offset
+000
Print Setup 7/12
Offset
Shift X
> Shift Y
Shift Y
+000
This option is used to fine tune print position. Press the button to move the cursor
from left digit to right digit, and press the button to set the value from “+” to “-” or “0” to
“9”. Press the button to set the value into printer. Press key to cancel
the setting and return to the previous menu. The default value is +000.