AMT Datasouth M5TT Plus User Manual
Page 19
Advertising
Document #120522 Rev-A
16
5. Feed the label, printing side facing up, through the paper guides and place it on
top of the platen.
6. Thread the label through the liner opening, which is beneath the roller and
tear off one piece of the label.
7. Adjust the paper guides by moving left or right to fit the label/backing width.
Fig. 20 Load label into peeler roller assembly
8. Lift the peel-off panel up and back into the closed position.
9. Close the top cover by lifting up the top cover support and
close the
top
cover
slowly.
Note: Pull the label outward removing slack after closing the top cover.
Fig. 21 Complete label installation for peel-off mode
Roller
Top Cover
Top Cover Support
Peel-off panel
Advertising