AMT Datasouth M5TT Plus - Manual (Page 39)

Document #120522 Rev-A 36
Printer
Initialization
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green after 5 amber
blinks. (Any green will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks)
green
(5 blinks) green/amber (5 blinks) red/amber (5
blinks) solid green
Note:
Always do gap/black mark sensor calibration after printer
initialization.
Set Black Mark
Sensor as Media
Sensor and
Calibrate the Black
Mark Sensor
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
green / amber
after 5
green blinks. (Any green/amber will do during the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks) green
(5 blinks)
green / amber (5 blinks)
red/amber (5
blinks) solid green
Set Gap Sensor as
Media Sensor and
Calibrate the Gap
Sensor
1. Turn off the power switch.
2. Hold on the button then turn on the power switch.
3. Release the button when LED turns
red / amber after 5
green/amber blinks. (Any red/amber will do during the 5
blinks).
The LED color will be changed as following:
Amber red (5 blinks) amber (5 blinks) green
(5 blinks) green/amber (5 blinks)
red / amber (5
blinks) solid green