Setup, 1 instructions to top cover operation – AMT Datasouth M5TT Plus User Manual
Page 7
Document #120522 Rev-A
4
3. Setup
3.1 Instructions to Top Cover Operation
Please take care when opening or closing the printer’s top cover by carefully
following these instructions.
To Open:
1. When facing the front of the printer pull the cover release levers on both sides
of printer towards you.
2. Lift up the top gradually.
There are two stop positions for the top cover. Position 1 and 2 are indicated on
the label below.
Note: To hold the cover open at position 1, you must lift the cover higher
than the stopping point at position 1 and gently lower the cover to stop
position 1.
DO NOT free fall the top cover!
3. Fully open the top cover and gently lower it to stop position 2.
Top cover support is fixed at position 2
4. To close the cover, lift up to the maximum angle and release. The cover will be
kept at a stop position between 1 and 2 for a while. Use both hands to gently
push down the top cover to close and make sure the cover is latched on both
sides.