ClassCo VoiceAnnounce Caller ID 9900CW - Manual (Page 20)

20
Q: It’s not announcing call waiting calls
Make sure the volume is set correctly (see ADJUST VOLUME
mode)
Call the telephone company to make sure call waiting ID service
has been activated and is working with your line properly.
Make sure you’re talking on the phone plugged into the back of
the caller ID unit
Make sure the power cord is correctly plugged in.
Make sure the phone line coming from the wall is going to the
LINE jack on the unit and the phone cord coming from your phone
is going to the PHONE jack on the unit.
If you have another call waiting ID device, try unplugging it.
Q: How do I stop the LED from blinking?
Review all new calls by repeatedly pressing the REV key until all
calls in the call log have been displayed.
Hold the CLEAR key down for 4-seconds to clear the call log.
Check Voice Mail
If the LED still blinks, unplug the unit from power for 10-seconds
then plug back in.
Q: How do I set the DATE and TIME display?
The time and date will be set automatically with the first incom­
ing call. They will be reset with each new call. You cannot change
the time or date manually.