Ditch Witch P80 - Manual (Page 48)

P80/PP25 Operator’s Manual
Push Rods - 47
Setup
CMW
6. Slide a rod through cylinder and install pilot head.
7. Fasten chain and lift rod pusher in level position. Lower unit
into trench.
8. Attach hydraulic control hoses to power unit hydraulic
manifold. Connect other hoses from hydraulic control valve
block to rod pusher.
9. Align Unit with intended bore path.
10. Place a level on push rod at rear of unit. Adjust angle to
match grade of bore.
NOTICE: Hydraulic hoses DO NOT connect under
pressure. Stop unit before connecting hydraulic
hoses.