Ditch Witch RT45 - Manual (Page 101)

Backhoe - 102
RT45 Operator’s Manual
Setup
CMW
®
Setup
1. Move attachment speed/direction control to neutral position.
2. Move ground drive control to neutral position.
3. Engage parking brake if not on level ground.
4. Lower rear attachment to 6” (150 mm) above
ground.
5. Check that backfill blade is straight and lower
it to ground.
6. Decrease engine speed to low throttle.
7. Move to backhoe operator’s station.
8. Release seat lock (shown) and move seat
into operating position.
9. Lower stabilizers enough to lift front tires.
10. Disengage stow lock.
11. Adjust engine speed to 1/2 to 3/4 throttle for
digging.
IMPORTANT: Engine speed affects
speed of backhoe operation.