Ditch Witch RT45 - Manual (Page 116)

RT45 Operator’s Manual
Microtrenching - 117
Setup
CMW
®
Before First Use and After Replacing Bits
Check Bit Clearance
For blades using 10 mm rotating conical bits
1. Remove blade cover.
2. Check that all bits are properly secured.
3. Check that all bit retaining pins are secure.
4. Ensure blade retaining nut is tight.
5. Turn blade by hand and make sure bits do not hit metal frame.
6. If bits hit frame, repeat steps 2-5 to make sure bits are in the proper location and secured at proper
depth.
7. If bits do not hit frame:
• Install blade cover.
• Fasten and adjust seat belt.
• Start tractor and adjust throttle.
• Raise microtrencher slightly.
• Use attachment speed/direction control to rotate blade slowly. Listen for clicking sounds. If clicking
is present, turn off tractor and repeat steps 1-6.
Read operator’s manual. Know how to use all controls
before operating machine. When you see this sign on the machine or
in the manual, read it and use caution. Your safety is at stake.
273-475
To help avoid injury: Perform all service with tractor off and parking brake set, unless otherwise
instructed. If attachment must be raised for service, only raise it enough to clear the ground.
Note: If new bits and deflectors are installed, it is normal for bits to hit the deflectors until a
portion of the deflector is worn away.