Setup for 5.1 or 7.1 surround sound, Setup for 5.1 or 7.1 surround sound -13 – Eurocom P180HM Leopard 2.0 User Manual
Page 59
Storage Devices, Mouse, Audio & Printer
Audio Features 2 - 13
2
Setup for 5.1 or 7.1 Surround Sound
To setup your system for 5.1 or 7.1 surround sound you will need to connect the au-
dio cables to the Headphone-Out, Line-In, Microphone-In jack and S/PDIF-Out
jacks (note: the S/PDIF jack is used for 7.1 surround sound only).
1.
Click Start, and click Control Panel (or point to Settings and click Control Panel)
and make sure you are in Classic View.
2.
Click Realtek HD Audio Manager (or right-click the notification area icon
and
select Sound Manager).
3.
Click Speakers (tab) and click Speaker Configuration (tab).
4.
Select 5.1 or 7.1 Speaker from the Speaker Configuration pull-down menu.
THX Audio & HDMI
Note that the THX audio
effects do not apply to
audio generated
through an HDMI con-
nection (see page
).
Press the THX TruStu-
dio Pro Touch Sensor
Instant Key
to tog-
gle the THX TruStudio
AP On/Off.
Figure 2 - 10
Speaker
Configuration (7.1)
Auto Popup Dialog
You should enable the
auto popup dialog to au-
tomatically detect when a
device has been
plugged-in. If disabled,
double-click connector
settings
and click the
box to enable the auto
popup detection of
plugged-in devices.
Connector Settings