Harmonic Resolution Systems SXR Audio Stand User Manual
Page 12
At this point the screws connecting the Cross Brace sub assembly should be fully
tightened. Before tightening screw fully be sure that the Cross Brace and Support
Brace are completely perpendicular to each other as shown in Photo 2. Tighten
screws (shown in Photo 3) until the screws stop turning and the top of T-Wrench
handle twists an additional 1/16 to 1/8 of a rotation relative to the bolt. This will
give you proper torque on the assembly. Repeat steps 1 and 2 for the opposite side
of the Cross Brace with again checking that the two parts are perpendicular to
each other (minor adjustments can be made prior to torque of the bolts). After the
8 bolts are tightened check one more time to make sure the Struts are still sitting
into the counter bores on the backside of the Support Brace.
As done in Step 3 add a polymer ring to each of the threaded ends of the struts (see
Photo 11) Make sure the Polymer Ring sits into the counter bore of the Support
Brace.
Photo 10