Harmonic Resolution Systems SXR Audio Stand - Manual (Page 5)

Set-Up Instructions
The SXR Audio Stand consists of a frame structure and the isolation bases that
support each component. The components required to assemble the frame are
shipped in one or more boxes. The number of boxes depends on the system size.
Each box containing parts for the frame will be marked with the model number
starting with SXR. All the wrenches required to put the frame together are included
with the shipment. The only tools not provided that will be useful for assembly is a
level. We recommend a standard 12” level bubble level or equivalent.
Work Surface - Prior to unpacking any material, locate a very strong and very
stable work surface (capable of supporting 250 lb. load) or area on the floor that
will give you a very soft scratch resistant work area that is at three feet by three
feet in size. The more space you have the better, as it will give you room to move
around the frame to complete assembly. It is important that the area be free of all
dirt, screws or small pebbles, and that it is covered with a clean soft protective
blanket of same size that will prevent damage to high quality finish on the frame.
Unpacking Assembly Hardware - Remove all the contents from all the boxes
marked with SXR model number. Place all the hardware on a table adjacent to
your selected work surface and remove all the wrapping material. Be careful not
to drop or allow the anodized aluminum parts to contact each other as they may
scratch the surface. Do not stack the parts on top of each other once they are
removed from the protective packaging material. To make assembly easier group
identical parts together in an organized manner. Make sure all tubes are matched
for proper (same) length.
This audio stand will be assembled upside down. Depending on what frame
configuration you have purchased there will be a number of Support Braces that
have threaded studs already attached. Do not try to remove these threaded studs
as they are attached to the frame. These Support Braces with threads will be the
top of the audio stand.
Note:
Depending on how your SXR audio stand frame was shipped it may arrive
partially assembled. This means Steps 1 and 2 would have been completed so the
Support Braces and Cross Braces will already be attached. If your SXR was
partially assembled, complete assembly by skipping Steps 1 and 2 and referring to
the instructions at Step 3.