Harmonic Resolution Systems SXR Audio Stand User Manual
Page 9
Step 5
. By hand screw the struts onto the threaded studs as shown in Photo 6. If
you have a stand with different size struts keep in mind that you are building the
stand upside down. The struts you are installing now are the struts that will
become the struts between the top and second shelf when the stand is completed.
Note: Shelf spacing is approximately 3” less than the strut length. Verify you have
the correct strut length required for your system. HRS offers a variety of strut
lengths so consult your dealer if you are not certain you have the correct parts for
your desired spacing.
Step 6.
Screwing the struts (of same length) onto the threaded studs will begin to
get more difficult when they come in contact with the polymer rings. To tighten the
struts more firmly use the MagiGrip tool supplied with the unit. To do this tighten
the rubber strip firmly around the strut and turn handle. The teeth on the
MagiGrip should be pointed in the direction of rotation. The strut has proper
torque when it is 1 full turn (360 deg) after the strut is finger (snug) tight. For
example Photo 7 below shows a strut being tightened by rotating the MagiGrip
clockwise.
Photo 5
Photo 6