Harmonic Resolution Systems SXR Audio Stand User Manual
Page 6
Step 1.
Obtain one of the Support Braces with threaded studs. Place it upside
down on the work surface with threads facing up (see photo 1). Obtain a Cross
Brace and flip this over as well as shown in the photo below. Slide one of the ends
of the Cross Brace into the area below the countersunk holes on the Support
Brace. The countersunk holes of the Support Brace should line up with the
threaded holes of the Cross Brace.
Step 2.
Using the 5/32” Allen wrench (supplied with stand) attach the Cross
Brace to the Support Brace with the 1/4” - 20 x 3/4” flat head cap screws (also
supplied with the unit). Before tightening screw fully be sure that the Cross Brace
and Support Brace are completely perpendicular to each other as shown in Photo
2. Tighten screws (shown in Photo 3) until the screws stop turning and the top of
wrench handle twists an additional 1/16 and 1/8 of a rotation relative to the bolt.
This will give you proper torque on the assembly. Repeat steps 1 and 2 for the
opposite side of the Cross Brace with again checking that the two parts are
perpendicular to each other (minor adjustments can be made prior to torque of the
bolts).
Note: If assembling a double or triple wide SXR the Center Brace will be installed
to the other side of the Cross Brace.
Photo 1