27 installation, Installation procedures – Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) User Manual

Page 27

Advertising
background image

27

Installation

IND100078-31

Installation Procedures

Panel / Console Mounting Bracket Kit for 12”,15”,17”,19” - Single Key Hole

You need: Allen Wrench tool (3mm), 4 pcs of HD CMB SX1-A1 / -A2 or -A3 Kit (-A1 or -A2 included in delivery).

Procedure suitable for: Display and Panel Computers with Single Key Hole. Brackets are EN60945 Tested.

Attention: A suitable pre-cut panel cutout should be made prior to mounting. Do not force the

unit into the panel cutout as it might break the outer glass or scratch the chassis on the unit. Make

sure that the panel cutout is not too tight for the unit. Please disconnect ALL cables before

proceeding. Please re-check the relevant and required panel cutout measurements if unsure.

Confirm you have the

Single Key Hole

model before

proceeding!

1: Slide the unit into the cutout carefully.

User Controls and Connector Area should

be facing downwards.

2: Prepare and position the brackets into each

of the four key holes. The key part goes into

the unit’s largest area of the keyhole, while the

Allen screw is visible at the top. See closeup.

3: When all brackets fits inside the keyhole, slide them down into the narrow gap. If you are unable to slide them

down, simply adjust/loosen the top Allen Screw slightly and try again.

4: Secure the unit by fastening the top Allen screws fairly. Make sure you do it equally and even for all 4 sides. Do

not use excessive force. See closeup of a open and closed position to the right.

Open Closed

Advertising