Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) - Manual (Page 52)

52 User Controls
IND100064-38
OSD Menu Functions
On Screen Display (OSD) Menu Functions
The following section covers all possible settings that the user can (in a certain mode) encounter or needs
to adjust via easy understandable menus, text and navigation. For simpler reading the menu choice “Exit”
has been left out of description in this chapter intentionally. Whenever “Exit” is available, you can exit
current menu and go back to the previous one visited. When there is no more previous menus available,
the OSD menu overlay will be shut off and hidden. All settings are saved real-time or when you exit a menu
(including time out of menu visibility).
The number shown in the “|------x------” line gives the indication of the submenu level where the function is
located (also reference to the table in the previous chapter). It requires the user to touch the “MENU”
symbol to enter that submenu.
Please note: Available functions described may deviate slightly from actual OSD menu on your unit.
This is due to different OSD software configurations and customized solutions. Shown here are factory standards.
Input Source Settings
Lets you configure Main and Secondary signal source inputs (DVI, VGA or Composite video signals) as well
as activate or disable the Auto Source functionality. The contents of these submenus are listed below.
|---2---
Input Source Settings - Main Source
The possible signal inputs are; “Digital 1” (DVI), “Digital 2” (DVI), “Analog VGA1” (RGB/VGA),
“Analog VGA2” (RGB/VGA), “Composite 1”, “Composite 2” and “Composite 3” (Composite Video).
Video inputs supports standard PAL/NTSC/SECAM signals.
● Note: The current active main source name will be greyed out in the list. By factory default, “Digital 1” (DVI) are assigned
as Main Source. The current active main source will be shown in green color at the bottom of this menu.
|---2---
Input Source Settings - Second Source
The possible signal inputs are; “Digital 1” (DVI), “Digital 2” (DVI), “Analog VGA1” (RGB/VGA),
“Analog VGA2” (RGB/VGA), “Composite 1”, “Composite 2” and “Composite 3” (Composite Video).
Video inputs supports standard PAL/NTSC/SECAM signals.
● Note: The current active secondary source name will be greyed out in the list. Also, if VGA or DVI are defined as Main
Source, they cannot be re-selected as second source as well. The second source is used together with Main Source for
the Picture-in-Picture (PIP) functionality. PIP works only with one source of DVI/VGA together with Composite Video
sources. By Factory default the second source is unassigned. The current active main source will be shown in green
color at the bottom of this menu.
|---2---
Input Source Settings - Auto Source Select
Set to either ‘Enable’ or ‘Disable’. Signal is automatically searched for and selected. If the Main
Source signal is disconnected physically, the video controller will automatically search and select
from the next item available in the list, such as; “Digital 1” (DVI), “Digital 2” (DVI),
“Analog VGA1” (RGB/VGA), “Analog VGA2” (RGB/VGA), “Composite 1”, “Composite 2” and
“Composite 3” (Composite Video).
● Note: If all signals was physically disconnected from the unit, the Auto Source function will loop endlessly until it detects
a valid signal to display.