Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) - Manual (Page 84)

84
IND100129-154
All specifications are subject to change without prior notice!
Specifications - HD 26T21 MMD-xxx-Fxxx (LED/CCFL version)
SPECIFICATIONS
Note: All specifi cations are subject to change without prior notice!
Please visit www.hatteland-display.com for the latest electronic version.
2/2
• W:621.00 [24.45''] x H:435.00 [17.13''] x D:98.20 [3.86''] mm [inch]
• 4 x M6 VESA mounting 280x150mm, Max 12mm deep
• Weight: 14.8kg / 32.6lbs
• High Quality TFT with LED or CCFL Backlight Technology
• 25.54 inch viewable image size, Widescreen, Aspect Ratio 16:10
• S-MVA, Active Matrix, Thin Film Transistor (TFT)
• RGB Vertical Stripe
• Native Resolution : 1920 x 1200
• Pixel Pitch (RGB) : 0.2865 (H) x 0.2865 (V) mm
• Response Time (CCFL) : 8 ms (typical), "gray" to "gray"
• Response Time (LED) : 20ms (Tr+Tf)
• Contrast Ratio : 1500:1 (typical)
• Light Intensity : 350 cd/m 2 (typical)
• Viewable Angle : +/- 88 deg. (typical) (Up/Down/Left/Right)
• Active Display Area : 550.08 (H) x 343.8 (V) mm
• Max Colors : 16.7 million
Multi-power Supply:
• 115&230VAC - 50/60Hz + 24 VDC - HD 26T21 MMD-Mxx-Fxxx
Note: You may connect either AC power or DC power or both. In case both sources
are connected, power will be sourced from the AC input. If AC input is lost, there will
be a uninterrupted switch-over to DC input.
Power Consumption:
• Operating AC/DC: 107W (typ) - 125W (max)
A P P R O V A L S & C E R T I F I C A T E S
Physical Considerations: TFT Technology:
TFT Characteristics:
Power Specifications:
This product have been tested / type approved by the following classification societies:
IEC 60945 4th (EN 60945:2002) IACS E10 ClassNK - Nippon Kaiji Kyokai GL - Germanischer Lloyd
DNV - Det Norske Veritas ABS - American Bureau of Shipping CCS - China Classification Society BV - Bureau Veritas
LRS - Lloyd’s Register of Shipping EU RO MR - Mutual Recognition
• Digital separate synchronization
• Composite synchronization
• Synchronization on green
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal : Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronization Range:
• Horizontal : 31.5 kHz to 91.1 kHz
• Vertical : 60 Hz* to 85 Hz
* Recommended for optimal picture quality
Resolutions:
• VGA : 640 x 480 (including 640 x 350)
• SVGA : 800 x 600 (including 720 x 400)
• XGA : 1024 x 768
• SXGA : 1280 x 1024
• UXGA : 1600 x 1200
• FHD : 1920 x 1080
• WUXGA : 1920 x 1200*
* Recommended for optimal picture quality
Video Signals:
• Interlaced HDTV, NTSC, PAL and SECAM video
• Composite video
Synchronization:
Supported Signals:
• DVI-D Signal IN : 2 x 24p DVI (female)
• RGB Signal IN : 2 x 15p HD D-SUB (female)
• Comp. Video IN : 3 x BNC Connector (female)
• SCOM RS-422/485 : 1 x 5-pin Terminal Block 3.81, non-isolated+Buzzer
• RGB Signal OUT : 1 x 15p HD D-SUB (female) - Clone of RGB IN*
• If Touchscreen : 1 x USB TYPE A Connector (female)
• Ethernet : 1 x RJ45 Connector for Remote Control
• SCOM RS-232 : 1 x 9p D-SUB (female) non-isolated
• Potmeter : 1 x 9p D-SUB (male)
(Potentiometer IN, +5VDC OUT, BRT +/- IN)
• AC Power IN : 1 x Std IEC Inlet
• DC Power IN : 1 x 2-pin Terminal Block 5.08
*Tested at recommended resolutions. The RGB output signal is at same resolution and
sync as the RGB input. The output is working even if the display unit is turned off, but
power cable/supply must be connected/provided.
Signal Terminals:
• Operating : Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
• Storage : Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
• IP Rating : Protection: IP66 front – IP22 rear (EN60529)
• Compass Safe Dist. : HD26T21MMD-xxx-Fxxx - Std: 130cm Steering: 70cm
Lifetime Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Behind front bezel - Glass Display Control™ (GDC) IP66:
• Power On/Off, On Screen Display Menu, Brightness Control (-/+)
• Hotkeys (left/right), Mode Status Indicators (ECDIS, Service)
• Buzzer (not visible), Light Sensor (not visible)
• Projected Capacitive Touch Screen (Multitouch, USB interface)
• Capacitive Touch Screen w/Cosmetic alu front frame (USB, -FxxC model)
• Optical Bonding Technology
• Color Calibrated models (ECDIS)
• Single AC Power 115&230VAC - 50/60Hz Input
Environmental Considerations:
User Controls:
Factory Options:
For a full overview of typenumbers, please review the following link:
www.hatteland-display.com/pdflink/ind100780-3.php
• HD CMB SX1-C1 : 1 x Console Mount Kit. EN60945 Tested
• HD TMB SX1-C1 : 1 x Table Mount Bracket. EN60945 Tested
• HD VED SX1-A1 : 1 x VESA Bracket, not EN60945 Tested
Please see user manual/datasheet for more information
Available Accessories: