55 user controls, Osd menu functions – Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) User Manual

Page 55

Advertising
background image

55

User Controls

IND100064-38

OSD Menu Functions

|---2---

Image Settings

- Hue

*Available in “Full Mode” only + Video Fullscreen

Allows to adjust/shift the main color properties of all Red, Green, Blue and Yellow (unique hues)

values. This can be useful for certain Composite Video sources (no effect on DVI/VGA signals)

whose output may have shifted or seems to be “out of phase”, where for instance blue seems more

dominant than green, red and yellow-ish colors. By using HUE one can shift the entire color range

of all components left or right in the spectrum.

● Note: Value adjustable from 0 to 100. 50 is factory default.

|---2---

Image Settings

- Sharpness

Increase/decrease the overall image sharpness. This affects the active display area, and applies to

all signal inputs and window overlays (PIP/PBP). Use it to increase the visual quality of signals from

possible older equipment or improve electronically weak signals.

● Note: Value adjustable from 0 to 24. 12 is factory default. Available for RGB/VGA, CVBS modes only.

|---2---

Image Settings

- Display

Allows to adjust DVI/VGA signals Horizontally (left/right) and Vertically (up/down) within the TFT

panel Active Area. If the incoming signal is “Analog VGA 1 (RGB/VGA)” only, Clock and Phase can

also be adjusted (if there seems to be a “waterfall / rolling bars” effect present in the active display

area).

● Note: This function can move information in the image outside the visible TFT Active Area, so use caution when

modifying this parameter. Try to determine the max end of borders (look at each corner) of the image before you

proceed using this function.

|--------3--------

Image Settings - Display

- H Position

Settings as follows:

“H Position” = Move image within the TFT panel active area Horizontally (left/right),

values from 0 to 100.

● Note: Default value is centered inside the active TFT panel area.

|--------3--------

Image Settings - Display

- V Position

Settings as follows:

“V.Position” = Move image within the TFT panel active area Vertically (up/down),

values from 0 to 100.

● Note: Default value is centered inside the active TFT panel area.

Advertising