51 user controls osd menu overview, Management settings (page 64-69), Service settings (page 70-71) – Hatteland Display 26 inch - HD 26T21 MMD (Widescreen, Touch Screen) User Manual
Page 51
51
User Controls
OSD Menu Overview
IND100064-39
Management Settings (page 64-69)
Level 1 (Main Menu)
Level 2
Level 3
Level 4
Level 5
Management Settings > < Exit
* Graphic Scaling >
< Exit
Graphic Scaling >
Full Screen,
Fill to Aspect Ratio, 1:1
Zoom >
(Slider Bar)
Horizont Stretch >
(Slider Bar)
Vertical Stretch >
(Slider Bar)
Auto Adjustment >
On, Off
*Unknown Timing Search >
< Exit
Auto Mode >
< Exit
Display Size >
4:3, 5:4, 1:1, 16:9, 16:10
Execute >
(Automatic Action)
Blind Mode >
< Exit
Hor. Resolution >
(Slider Bar)
Ver. Resolution >
(Slider Bar)
Total Hor. Line >
(Slider Bar)
Hor. Blank Pixels >
(Slider Bar)
Ver. Blank Pixels >
(Slider Bar)
Execute >
(Automatic Action)
Save Timing >
Slot 1 to 8 >
(Automatic Action)
Clear Timing >
Slot 1 to 8 >
(Automatic Action)
LED Drive >
(Slider Bar)
*GDC Sensitivity >
(Slider Bar)
*Filter >
On, Off
*VGA Out >
Enable, Disable
*VGA SEL >
Enable, Disable
*Communication >
< Exit
RS232 >
(Select)
2-wire RS-485 >
(Select)
4-wire RS485/422 > (Select)
Address RS >
(Slider Bar)
IP Address >
Auto IP >
(Select)
Fixed IP >
(Number Input, xxx.xxx.xxx.xxx)
Download >
(Automatic Action)
Service Settings (page 70-71)
Level 1 (Main Menu)
Level 2
Level 3
Level 4
Level 5
Service Settings >
< Exit
GEV Firmware Ver >
(Text Displayed)
CYP Firmware Ver >
(Text Displayed)
Ethernet Ver >
(Text Displayed)
Elapsed Time >
(Text Displayed)
Current Temp >
(Text Displayed)
Fault Status >
< Exit
DVI Chip >
(Text Displayed)
NVRAM >
(Text Displayed)
Ethernet >
(Text Displayed)
GDC >
(Text Displayed)
TMP Sensor >
(Text Displayed)
Test Pattern >
(Automatic Action)
Burn In >
ON, OFF