HITEC X1 Pro DC/DC Multi-Charger - Manual (Page 34)

34
nicd/niMH - cYcle Mode (cont.)
Select the correct battery type by following the instructions on
page 29. Once you have set the correct battery type, toggle up (▲)
or down (▼) until you see the “
NiMh CYCLE
” screen.
The Cycle Mode gives you two cycling
options: “
DChG>ChG
“ or “
ChG>DChG
“. The
“
DChG>ChG
“ option will first discharged the battery and then
charge the battery. The “
ChG>DChG
“ option will first charge the
battery and then discharge the battery. If this screen does not cur-
rently show the cycling option you desire, toggle right (►) once
and this setting will begin flashing. Toggle up (▲) or down (▼) to
change this setting.
Toggling right (►) once will cause the
number of cycles option to begin flashing.
Toggle up (▲) or down (▼) to change this to the number of cycles
you want the X1Pro to execute. The X1 Pro can cycle the battery a
maximum of 5 times consecutively.
Toggle and hold the joysick to the right (►) for three seconds to
begin cycling.
Once cycling has commenced, the charger
will display the following real-time informa-
tion: battery type, charging/discharging current, battery voltage,
charging time and charged capactiy. You will also see “
D>C
“ or
“
C>D
“. This will indicate which cycling order you have chosen. Either
“
D
“ or “
C
“ will be flashing. This flashing indicates which part of the
cycle is currently being executed.
Once the cycling process is complete, the
X1 Pro will display the charge/discharge
capacity for each cycle. By toggling up (▲) or down (▼) , you can
scroll through this data for each cycle.
NiMh CYCLE
DChG>ChG 1
NiMh CYCLE
DChG>ChG
1
NiMh 0.1A 5.21V
D>C 015:42 00026
DChG 1 1314mAh
ChG 1 1430mAh
Pb (lead-acId)