Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 14)

The initial installation procedure described hereinserves
only as an example. The exact initial installation procedure
will depend on the settings you wish to make.
Please follow closely any instructions that appear on the
screen.
Menu/OSD language:
>
Press
OK to display the selection window for the
Menu/OSD language.
(Fig. 5-2)
> Use the
arrow keys up/down to select the prefer-
red OSD language.
> Confirm by pressing
OK.
Audio language
>
Use the
arrow keys up/down to select the prefer-
red audio channel language. (Fig. 5-3)
When the installation assistant has been completed,
your language selection here will be used to sort the
programmes in your Favourites list.
> Confirm by pressing
OK.
Country/Time Zone
>
Use the
arrow keys up/down to select the time
zone of the country in which you are located. (Fig. 5-4)
The time on the receiver clock will be set automatically
based on your selection.
> Press
OK to confirm, and to proceed to the antenna
configuration.
Antenna configuration
In this step of the installation procedure you can adjust the
setting of your digital receiver to the configuration of your
antenna.
>
If you wish to accept the standard antenna setting,
use the
arrow keys up/down to mark the field
Standard and confirm by pressing OK.
(Fig. 5-5)
In this case, proceed to the next item, “
Software
Update”.
> If the configuration of your receiving installation does
not correspond with the standard setting, mark the
field
Manual and confirm by pressing OK.
DiSEqC
>
If you are utilising DiSEqC components as part of your
reception installation, click on to the field
Activate
and confirm by pressing
OK
(Fig. 5-6). (Additional information on DiSEqC may be
found in Chapter 10: Technical Terms.)
14
(Fig. 5-5)
(Fig. 5-6)
(Fig. 5-2)
(Fig. 5-3)
(Fig. 5-4)
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 14