Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 66)

For daily use
Switching on and off
> Switch on the digital receiver by pressing the
On/Standby key, either on the receiver or on the
remote control.
> Press this key again to switch the receiver off.
> The receiver is now in standby mode, the display
* on
the receiver shows the time.
Programme selection
Using the programme up/down keys
> Use the
programme keys up/down either on the
remote control or on the receiver to move up or down
one programme slot at a time.
Using the numeric keys
> Use the
numeric keys to enter the desired program-
me number.
For example
1
for programme slot 1
1, then 4
for programme slot 14
2,
then
3, then 4
for programme slot 234
When entering programme numbers consisting of several
digits, you have approximately 3 seconds after pressing a key
to complete the entry.
If you wish to enter a number consisting of only one or two
digits, you can speed up the switching procedure by keeping
the key depressed a little longer on the last digit.
Using the programme list:
> Press
OK.
> You can now use the
arrow keys up/down to mark
the desired programme.
> Press the
yellow function key Preview to display a
preview of the marked programme.
> Press
OK to switch to the marked programme.
> Use the
arrow keys up/down to move the marker
by one line at a time within the list.
> Use the
arrow keys right/left to move the marker
around the list one page at a time.
Volume control
> You can regulate the volume of your digital receiver:
press the key
Volume + to increase the volume, and
Volume - to decrease it.
> Press the key
Sound on/off to switch the sound on
or off (mute).
66
* Only for receivers equipped with
this feature
080903
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:15 Seite 66