Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 58)

9.4 Current satellite list
The satellite positions stored in memory are shown in the
satellite list. Any positions not yet stored in memory are
marked with an “
*”.
> To adjust the antenna dish to a position on the satellite
list, use the
arrow keys to select the field Current
Satellite list.
> Confirm by pressing
OK.
> Use the
arrow keys up/down to select the desired
position.
> Confirm by pressing
OK.
The antenna dish will now be rotated to the selected
position. The rotating procedure will be indicated by a
blinking display “
rotating” in the menu.
9.4.1 Selecting a satellite position
To rotate the antenna to the position determined in the
satellite list, your digital receiver is equipped with the function
turn to Sat.
>
Press the
yellow function key Actions to open the
window displaying the available actions.
> Use the
arrow keys up/down to select the line
turn to Sat.
> Confirm by pressing
OK.
> Pressing the
green key turn to Sat will rotate the
antenna to the selected satellite position.
9.5 Deleting a satellite position
To delete a satellite position from the satellite list, proceed as
follows:
>
Use the
arrow keys to mark the field Current
Satellite list.
> Press
OK to open the current satellite list.
> Use the
arrow keys up/down to select the satellite
you wish to delete.
> Confirm by pressing
OK.
> Use the
arrow keys to mark the field Sat delete.
> To delete the satellite selected, press
OK and confirm
the message displayed by again pressing
OK.
9.6 Reference position
When installing the external installation the motor must be set
to the reference position (
0°). You can therefore rotate the
motor to this position (
0°) at any time by means of the
function “
Go to reference position”.
> Press the
red function key Ref.pos to rotate the
antenna automatically to the reference position.
58
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:15 Seite 58