Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 38)

> Use the
arrow keys up/down to move the marker
around the list one line at a time.
> Use the
arrow keys right/left to move the marker
backward or forward in the list one page at a time.
Date
>
Use the
arrow keys to mark the column Date.
> Use the
numeric keys to enter the date on which
you wish to record a programme.
Start
>
Use the
arrow key right to mark the column Start.
> In this line, use the
numeric keys to enter the star-
ting time for the timer.
Stop
>
Repeat the steps as described under “Start” to enter
the stopping time.
So that all timer events can be accommodated, there
should be an interval of at least one minute between the
stopping time of one timer event and the starting time of
the next timer event! Should there be an overlap between
two timer events, these will be highlighted in red.
Repeat (optional)
>
Use the
arrow keys to mark the column Rep.
> Press
OK.
A selection window will be displayed, offering various
suggested repeating intervals.
1x
Timer used once only
D
Daily repeat
1 W Repeat once weekly
1-5
Repeat only on weekdays
6-7
Repeat only on weekends
> Use the
arrow keys up/down to select the desired
function.
> Press
OK to accept the setting into memory.
Type
>
Use the
arrow keys to mark the column Type.
> In this line, press
OK to enter the desired status.
1. VCR
Your digital receiver will be switched on and off for the
programme selected.
If the receiver was switched on by the timer, this will
be indicated by “
rEc” on the display*. Most of the
functions of the remote control will be de-activated to
prevent an accidental interruption of the recording.
In standby operation the active timer will be indicated
by a blinking colon in the time display.
38
* Only for receivers equipped with
this feature
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 38