Dolby Laboratories Digital-Satellite-Receiver - Manual (Page 21)

> Confirm by pressing
OK.
The menu
Settings will be displayed.
(Fig. 6-7)
> Now use the
arrow keys up/down to select the
line
Antenna Configuration.
> Confirm by pressing
OK. The menu Antenna
Configuration will be displayed.
(Fig. 6-8)
The following settings may be made in this sub-menu:
6.4.1 Switching DiSEqC on or off
DiSEqC (
Digital Satellite Equipment Control) is a digital swit-
ching signal used to control DiSEqC-compatible components
via the antenna cable. If your external installation incorpora-
tes DiSEqC components, you must switch on (enable) the
DiSEqC control:
>
In this line, use the
OK key to select DiSEqC on or
off.
As only one LNC can be addressed if the DiSEqC
control is switched off, the menu is restricted to the
configuration of a single LNC.
6.4.2 Setting the switching matrix
The menu lists the four switching criteria of the DiSEqC con-
trol. Your receiver is pre-programmed so that ASTRA will be
received on the position A/A and Eutelsat on the position B/A
of a multiswitch. If the switching matrix of your receiving
installation is set up differently, or if you are receiving other
satellites, proceed as follows to adjust your digital receiver to
the requirements of your receiving installation.
>
Use the
arrow keys to select a DiSEqC switch posi-
tion (1-4) you wish to allocate to a particular satellite
(e.g.
A/B 3 No Satellite), by simply marking this
line.
> Confirm by pressing
OK.
A selection table listing various satellites will be
displayed.
> Use the
arrow keys up/down to mark the appro-
priate satellite.
The
arrow keys up/down will move the marker up
or down one line at a time, the
arrow keys
right/left will move forward or backward one page at
a time.
If the satellite you seek is not included in the list, plea-
se select one of the reserve slots, designated
User 1
to
User 14.
> Confirm by pressing
OK. The satellite selected will
now be added to the menu
Antenna
Configuration at the position previously marked.
21
(Fig. 6-8)
(Fig. 6-7)
A B
Position
Ausgang
A B
Position
Ausgang
A B
Option
Ausgang
Example:
bed_anl_DVB13 CIP_englisch_q5.qxd 08.09.03 11:14 Seite 21