LINK Systems OmniLink 5000 - Manual (Page 14)

April 17, 2000 Man ual Revisio n 1.0
2.6
Figure 2.2: Password Entry Sequence
Step A: Select the restricted item. In the example shown in Figure 2.2 the restricted item is Channel
2 High Limit. Once the parameter is selected then Softkey # 1, the upper vertical softkey
(Softkey # 1 is highlighted in Figure 2.2) , will display the legend “SELECT”.
Step B: A list of users that have access to this restricted item will appear. In the example shown in
Figure 2.2 only User Number One, User Number Two, and User Number Five have access to
this restricted parameter. The system may have several more users, but the three users listed
on the screen are the only users that have access to change a High Peak Limit. The user must
use the arrow keys to position the cursor on his user name. After placing the cursor on the
correct name, the user must press the SELECT softkey. The SELECT softkey must be
pressed even if there is only one user name displayed.
Step C: The display will show the selected user name and request the user password. The user must
enter the correct password and then press the ENT key.
Step D: Upon entry of the correct password, the user will be allowed access to the restricted item. In
the example shown in Figure 2.2, the user will have access to change the Channel 2 High
Limit.
After performing the steps listed above, the user will be logged in to the password system. The user will