LINK Systems OmniLink 5000 - Manual (Page 81)

April 17, 2000 Man ual Revisio n 1.0
10.1
Section 10
Section 10.1 Software Version
The information in this manual is based on tonnage monitor software version 1.08
Section 10.2 Configuration Code and Clear Stroke Counter/Memory Code
The Configuration Code used to gain access to the tonnage monitor configuration menus is the same
Configuration Code as used by the OmniLink 5000 press control.
The Clear Stroke Counter/Memory Code used to clear memory in the tonnage monitor is the same Clear
Stroke Counter/Memory Code as used by the OmniLink 5000 press control.
These codes are described in the OmniLink 5000 Press Control manual, provided to customer
supervisory personnel, and are not defined in this manual.