LINK Systems OmniLink 5000 - Manual (Page 22)

April 17, 2000 Man ual Revisio n 1.0
4.1
Figure 4.1: OmniLink Main Screen
Section 4 Operation
Section 4.1 Main Operator Terminal Screen
The Operator Terminal Main Menu shown in Figure 4.1 provides the current status of the tonnage
monitor module directly beside the TONNAGE MONITOR softkey.
The status of the tonnage monitor module could indicate any of the following conditions:
"OK" No tonnage alarms exist and no stop signals are being given by the
module.
"Error Condition Exists" A tonnage alarm or an error has been detected and must be reset before
press control will allow stroking. This will be displayed in red.
"BYPASSED" Tonnage module is bypassed and will not supply a stop signal to the press
control if an overload occurs. This will be displayed in yellow.
"Option is NOT Installed" Press control has not been configured to recognize the tonnage monitor
module.
"Communication Failure" A problem exists in the serial communication link between the operator
terminal and the tonnage monitor module (see section 9 for details). This
will be displayed in red.