LINK Systems 5100-8 Tonnage & Analog Signal Monitor - Manual (Page 19)

Doc #: L-802-1110 Page 17 Rev. 02
Figure 6 shows a four channel screen when viewing data window 1 tonnages. Notice that the major
difference between this screen and that of Figure 5 is the addition of three new parameters and the lack
of a REVERSE TONNAGE softkey.
Forward Tonnage
39.5
Tons
HIGH 150%
LOW 0%
9.8
Tons
HIGH 150%
LOW 0%
10.3
Tons
HIGH 150%
LOW 0%
11.4
Tons
HIGH 150%
LOW 0%
13.7
Tons
Module Status: OK
CHANGE
LOW LIMIT
Angles
Start Ang: 166.0
End Ang: 177.0
DATA WIN
ON/OFF
( ON )
CHANGE
ON ANGLE
CHANGE
OFF ANGLE
CHANGE
HIGH LIMIT
k l m
Stroke
Mode Single Stroke
Drive
Speed SPM
SPM
0
Order
Counter
Current Status
Counter OFF 0 0
Program/Run Switch
TOP
Stroke
Speed
Tonnage
Monitor
EXIT
CHANGE
VIEW
GRAPH BYPASS
SETP DIAGNOS
LOW LIMITS
ON/OFF
BYPASS
ON/OFF
CONFIGURE AUTO-SETUP
RESET
FAULT
View Total
Data Win 1
Low Limit: 9.1
Status OK
CH1 - Left Rear CH2 - Right Rear
CH3 - Left Front CH4 – Right Front
High Limit: 13.2
Low Limit: 8.1
Status OK
High Limit: 12.2
Low Limit: 12.0
Status OK
High Limit: 14.8
Low Limit: 8.5
Status OK
High Limit: 11.5
Forward Tonnage
39.5
Tons
HIGH 150%
LOW 0%
9.8
Tons
HIGH 150%
LOW 0%
10.3
Tons
HIGH 150%
LOW 0%
11.4
Tons
HIGH 150%
LOW 0%
13.7
Tons
Module Status: OK
CHANGE
LOW LIMIT
Angles
Start Ang: 166.0
End Ang: 177.0
DATA WIN
ON/OFF
( ON )
CHANGE
ON ANGLE
CHANGE
OFF ANGLE
CHANGE
HIGH LIMIT
k l m
Stroke
Mode Single Stroke
Drive
Speed SPM
SPM
0
Order
Counter
Current Status
Counter OFF 0 0
Program/Run Switch
TOP
Stroke
Speed
Tonnage
Monitor
EXIT
CHANGE
VIEW
GRAPH BYPASS
SETP DIAGNOS
LOW LIMITS
ON/OFF
BYPASS
ON/OFF
CONFIGURE AUTO-SETUP
RESET
FAULT
View Total
Data Win 1
Low Limit: 9.1
Status OK
CH1 - Left Rear CH2 - Right Rear
CH3 - Left Front CH4 – Right Front
High Limit: 13.2
Low Limit: 8.1
Status OK
High Limit: 12.2
Low Limit: 12.0
Status OK
High Limit: 14.8
Low Limit: 8.5
Status OK
High Limit: 11.5
Figure 6: Tonnage Monitor Main Screen Showing Data Window 1 Tonnage
In Figure 6, some additional settings in a data window view are:
k) Data Window
On/Off
This determines whether the data window is active. When “On”, the data
window setpoints are enforced from the “Start Angle” to the “End Angle”.
When “Off”, these settings are not used at all and will NOT stop the press.
l) Data Window
Start Angle
The angle at which the data window setpoints will start to be enforced.
m) Data Window End
Angle
The angle at which data window setpoints stop being enforced.