5 the tonnage monitor graph screen – LINK Systems 5100-8 Tonnage & Analog Signal Monitor User Manual

Page 32

Advertising

Doc

L-802-1110 Page

30 Rev.

3.5 The Tonnage Monitor Graph Screen

The GRAPH softkey in the main tonnage monitor screen provides the operator or die setter more
detailed analysis of machine forces by displaying tonnage signatures.

Figure 10 shows an example screen viewing peak tonnage information, Figure 11 shows the same screen
when viewing “data window 2” information, and Figure 12 shows the screen when in Pan/Zoom mode.
Notice that the shaded softkeys in these figures change depending on the circumstances.

Channel 1
Tonnage

EXIT

NEXT
CHANNEL

SELECT
PEAK/DATA
WINDOW

Use the

and keys to move the graph cursor

Use the and keys to move the parameter cursor

OVERLAY
GRAPHS

Angle: 180.0°

Tonnage: 89.8 Tons

Cursor Readout

CHANNEL 1 TONS - PEAK SETPOINTS

DW 1
DW 2
DW 3
DW 4

PEAK
INFO

Start

End

100.0

90.0
80.0
70.0
60.0
50.0
40.0
30.0
20.0
10.0

0.0

-10.0
-20.0
-30.0
-40.0
-50.0

160.0°

180.0°

200.0°

160°

200°

View Pts: 1085

ENTER PAN
ZOOM MODE

SEND
GRAPH

SHOW REF
GRAPH

HIDE REF
GRAPH

HI LIM

LO LIM

RV LIM

In Figure 10, some of the features of the screen are:

a) Cursor Angle

The angle at which the vertical measuring cursor (at 180 degrees in Figure 10
and pointed to by “h”) is sitting.

b) Cursor Tonnage

The numeric value of tonnage where the vertical measuring cursor (at 180
degrees in Figure 10 and pointed to by “h”) crosses the tonnage waveform.

95.0

82.3

18.2

DECREASE
XXXXXXXXX

INCREASE
XXXXXXXXX

CHANGE
NUMBER

GRAPH
SETTINGS

SHOW BY
TIME

SHOW BY
ANGLE

Cap Pts: 3143