Pitney Bowes DI950 FastPac Inserter - Manual (Page 13)

SV61311 Rev. E 1-3
Introduction • 1
DI900/DI950 are high throughput, mail creation systems designed to handle
a broad range of applications with minimum operator setup adjustments.
These systems have the ability to feed, fold, and insert mail piece compo-
nents into an outer envelope. The systems generate Letters or Flats as the
final mail piece. The systems also accept a variety of options that provide a
wide range of capacities and operating speeds.
About Your
System
The systems can be configured with four flexible Feeder Trays. There are
two types of Feeder Trays:
• Sheet Trays, which are capable of feeding sheets; and
• Insert Trays, which are capable of feeding slip/insert materials, pre-fold-
ed inserts, thin booklets, and envelopes.
In addition, the DI950 system is equipped with a dedicated High Capacity
Envelope Feeder (HCEF) that allows for greater speed and throughput. The
systems also accept material from optional upstream input devices, such as
High Capacity Sheet Feeders, Attached Printer, and other devices.
Basic system features are summarized in this chapter. Refer to Chapter 6
for detailed equipment and material specifications.
The systems are configured with two major components:
• Feeder Tower, and
• Transport Deck.
The Feeder Tower sends material from the Feeder Trays to the Transport
Deck. Depending on the job parameters, the material may or may not need
to pass through the Folder in the Transport Deck. If it does, the system of-
fers numerous types of folds and the ability to insert the folded material into
the appropriate position in the mail piece collation. The system can also seal
the envelope (Letter only) before sending the final mail piece to a stacking
unit.
Figure 1.1: The DI900 System