Pitney Bowes DI950 FastPac Inserter - Manual (Page 150)

8-6 SV61311 Rev. E
8 • Scanning
When the job you are running includes scanning, you will need to:
• Have the BCR or OMR Scan Configuration Worksheet or some such list-
ing of the required scan marks.
• Enter the settings into the Configurations screen for each item included
in the job's Scan Configuration.
• Add the Scan Configuration to the job, so the system knows which items
are scanned.
The BCR or OMR Scan Configuration Worksheet is a document prepared by
the system supplier or someone who manages your system. This document
contains information about scan marks for the job that you are running. You
will need to enter this information in the appropriate Configuration screens.
NOTE: Entry of a access code or password from a Supervisor and/or Manager
is required for use of these functions. Refer to Access Rghts in Chapter 2 in this
guide for more information about logging in using the two security modes.
Setting Up
a New Scan
Configuration
To setup an OMR Scan Configuration:
1. From the Home screen, select "Menu" then "Tools".
2. Select "Configure System" then "Scan Configuration Setup".
NOTE: If you are not logged in with supervisor or manager access rights, you
will be prompted to enter an access code.
3. Select "OMR".
4. The Scan Configuration Setup screen displays. Select "Create New
Item".
5. Enter the Scan Configuration name using the alphanumeric matrix.
Press "Finished" when you are done.
NOTE: The Scan Configuration name cannot be longer than 9 characters.
Additionally, all names must be unique across all scan types. That is, an OMR
Scan Configuration name cannot be the same as a BCR Scan Configuration
name.
6. The Create OMR screen displays. Select "Add Item".
Setting Up an
OMR Scan
Configuration