Pitney Bowes DI950 FastPac Inserter - Manual (Page 135)

SV61311 Rev. E 7-9
Add-On Modules • 7
Attached
Printer
The Attached Printer add-on module attaches to the Feed Tower end of the
system to provide one-step printing and inserting, typically into windowed
envelopes. The Attached Printer has two sheet trays and a horizontal trans-
port (printer interface accumulator).
There are two printing options available with the Attached Printer: mono-
chrome (prints black and while only) and color. The sheet trays on the
monochrome printer hold up to 2000 sheets of 20 lb. (80 gsm) paper. The
sheet trays on the color printer hold up to 2000 sheets of 20 lb. (80 gsm)
paper with the optional extra trays.
The Attached Printer operates with other system options, including stackers,
postage printing, and one High Capacity Sheet Feeder. If present, the At-
tached Printer must be the most upstream device in the configuration.
IMPORTANT:
• When creating a job, you must indicate that the Attached Printer is the printing
source of the job. Refer to Chapter 3, Sheet Optons for more information.
• When setting up a Scan Configuration, you must set MC to "Is Controlling" to
notify the inserter that the control instructions will be based on the MC read
on each document. Refer to Setting Up an OMR Scan Configuration or Set-
ting Up a BCR Scan Configuration in Chapter 8 for more information.
7.10: Monochrome Printer Attached to System 7.11: Color Printer Attached to System