Waldorf Wave 3.v - Manual (Page 24)

The Controls
PPG Wave 3.V User´s Manual 24
• Arrow Keys Up / Down select the previous / next file
or folder in the file browser.
• Arrow Keys Left / Right close or open a selected
folder.
• Return (or Enter) loads the selected entry into PPG
Wave 3.V memory. A Program File is loaded into the
currently selected program, a Bank File replaces the
whole memory of PPG Wave 3.V.
Dragging:
• Move – Drag and drop inside the File Browser or
between the Finder [Mac] or the Explorer [Windows]
moves the selected files or folders to the highlighted
folder. Note: the files and folders are *moved*, so
they are *removed* from their original location and
created at their new location. If you don't want that,
use the copy command below.
• Copy – Holding Option [Mac] or Alt [Windows]
during the drop operation copies the selected files or
folders to the new location.
• Load – Drag of selected files to the Program Table
loads them into PPG Wave 3.V RAM starting at the
highlighted location.
The Analog Control Panel
BASIS
The BASIS dial controls the position of voices
within the stereo panorama (pan). If this is set
to 0, all voices are audible in the middle of the
stereo spectrum. If you turn it to the right,
voices in POLY mode alternate between a left
and a right pan position. In DUAL, QUAD
and MONO modes, voices are equally spread
within the stereo spectrum. This function only
makes sense, if you monitor your audio signal in stereo.
w
In contrast to the original PPG, where it could
happen that two consecutive voices would sound on
the same channel, voices in the PPG Wave 3.V
always sound alternatively for each channel.
VOLUME
This dial is used to set the overall output volume of the
PPG Wave 3.V. It is a good idea to lower the Volume
value, if a sound tends to distort anyway because of its
settings.