Waldorf Wave 3.v - Manual (Page 37)

The Controls
37 PPG Wave 3.V User´s Manual
m
If you have loaded a Transient, Wavetable playback
for the corresponding Programm is disabled.
BANK Diverse
Bank chooses a desired presets bank containing different
wavetables. Click on the horizontal arrow buttons to
switch between the banks. Alternatively you can click on
the arrow down button to open a pop down menu for
faster bank selection.
UPPER WAVES ON / OFF
In addition to the 64 Waves per Wavetable, Upper Waves
are available. This is another Wavetable, which provides
another 64 Waves. Click ON to activate the Upper
Waves. The Upper Waves reside above the regular
Wavetables and expand the Spectrum of the Wave
scanning. Only one Upper Waves “Wavetable” is
available and it is identical for all Wavetables.
w
The original PPG Wave 2.3 could only provide the
upper Wavetable to the Sound on the first Part. In the
PPG Wave 3.V UPPER WAVES can be active on each
channel.
SUB-WAVES OFF, OFFSET, DIRECT, ENV 3
Use this function to activate the Sub Wave oscillator. Four
different settings are possible:
• OFF switches the Sub oscillator off. The Wave
oscillator will sound twice as loud to compensate for
the difference in volume.
• OFFSET is the preferred setting. In this mode, the
value to which WAVES-SUB is set, is added to the
value set for WAVES-OSC. If you e.g.set WAVESOSC
to 20 and WAVES-SUB to 10, the oscillator will play
Wave 20, while the sub oscillator will play Wave 30.
Offset can also be used in connection with the
possible Wave oscillator modulations. The switch
UPPER WAVES also applies to the sub oscillator in
this setting, as this still concerns an Offset between
sub oscillator-waveform and oscillator-waveform.
•
DIRECT means that WAVES-SUB plays the set
waveform directly, and that no modulation can
change it. If you e.g. want to perform a Wavescan
only for the main oscillator, while the sub oscillator
should play a fixed wave, then select this setting. The
switch UPPER WAVES has no impact here.