Pilz PSSu E F 2DOR 8 - Manual (Page 16)

Installation
Operating Manual PSSu E F 2DOR 8(­T)(­R)
21334­EN­07 16
} All contacts should be protected from contamination.
} The mechanics of the base modules are designed for 50 plug in/out cycles.
Procedure:
} We recommend that you wire up the base modules before inserting the electronic mod­
ules.
} Slot the groove on the base module on to the mounting rail from below [1].
} Push the base module back [2] until you hear it lock into position.
} On the mounting rail, slide the base module to the left until you hear the two lateral
mounting hooks on the adjacent module lock into position [3].
Schematic representation:
[2]
[1]
[3]
5.3 Inserting and removing an electronic module
Please note:
} Only insert on to base modules that are already installed.
} Preferably these base modules should be ready wired.
} Electronic modules with outputs may only be inserted and removed when the load is
switched off. Unforeseeable error reactions may be triggered if modules are inserted
and removed under load.
} When an electronic module is plugged into a base module for the first time, one part of
the coding element remains on the electronic module, while its counterpart is fixed on to
the base module. This is how the base module is coded.
} The mechanics of the electronic modules are designed for 50 plug in/out cycles.